output power
英 [ˈaʊtpʊt ˈpaʊə(r)]
美 [ˈaʊtpʊt ˈpaʊər]
输出功率; 缩写词为OP
双语例句
- The output power can never equal the input power, for there are always losses.
输出功率决不可能等于输入功率因为总有损耗。 - The output power can be adjustable in a certain range by operation of APC adjustment.
通过调节APC，可在一定范围内调节输出功率。 - Output power and frequency channels are easily programmable by use of the3-wire serial interface.
通过3线串行接口，可以很容易的利用程序对输出功率和通信频道进行配置。 - The limiting factor in output power is the average dissipation of the output devices.
制约因素是在输出功率的平均损耗的输出设备。 - Cascaded fiber amplifier with high repetition rate, short pulse-width all-solid-state laser seed can achieve high output power.
高重复频率、窄脉宽的全固态激光器种子源级联光纤放大器是获得高功率脉冲激光输出的有效手段。 - The matching inductor is added in resonance loop, and through parameter adjustment to reach load output power matching.
即在谐振回路中加入匹配电感，通过调整参数达到负载输出功率匹配的目的； - This is a similar tactic to that used to vary output power of multi-nozzle Pelton wheels and steam turbines.
这是一个类似的战术，即用不同的输出功率多喷嘴冲击式车轮和蒸汽涡轮机。 - Relationships between laser output power and average pumping power, temperature, repetition rate and mirror transmissibility are obtained.
研究了抽运功率、温度、重复率及输出镜的透过率对激光器输出功率的影响。 - The output power of laser can be exactly measured by the method of beam splitting monitoring.
通过分束监视，实现了激光输出功率的准确计量； - Low noise pump laser, high output power;
采用低噪声泵浦激光器，输出功率高； - The output power is stable at a given pump power.
在一给定泵浦功率下，其输出功率是稳定的。 - High output power, steady energy, adjustable, deep marking.
激光输出功率高，能量稳定，连接可调，深度雕刻。 - Or under same output power and load, the power supply voltage of the former is only one half of that for the latter.
或者，在输出功率和负载相同条件下，前者的电源电压仅为后者的一半。 - Output power can be flexibly adjusted;
输出功率可以灵活调节； - In order to maximize output power, IPMSG is controlled by a MPTT control and optimum efficiency control.
为了使输出功率最大，对IPMSG采用最大功率点跟踪（MPTT）和最大效率控制。 - At high wind speed, pitch angle is adjusted to keep rated output power.
在高于额定风速时，如何控制桨距角的变化，从而保持输出功率恒定的方法。 - Analysis of the microstructure, mechanical and corrosion distribution of the different output power of laser cladding.
对不同输出功率下得到的熔覆层微观组织和力学及腐蚀性能进行了表征。 - We calculated longitudinal confinement factor, threshold gain, optical gain and output power etc through theoretical model.
根据理论模型计算了纵模限制因子、阈值增益、光增益、输出功率等特征参数。 - Different types of DBR lasers are discussed and the oscillating frequency and output power of are deduced.
对不同结构DBR激光器的振荡频率及输出功率进行了理论推导。 - From the generation principle of switched reluctance generator ( SRG), two methods of enhancing output power were introduced, and a new switching strategy was focused on.
根据开关磁阻发电机（SRG）的发电原理，介绍了提高SRG输出功率的两种方法，重点介绍了一种新的开关策略，并对SRG在各种可能的开关角下进行了仿真。 - If the average dissipation can be decreased, more output power can be obtained.
如果平均损耗可降低，更多的输出功率可以得到。 - Gentle zones were found in all output power curves of laser-diode ( LD) side-pumped solid-state lasers.
在所有激光二极管（LD）侧面抽运的固体激光器的输出功率曲线中都存在一个平缓区域。 - Whether the main engine runs on the proper fuel oil will directly decide its operation and output power.
主机使用的燃油是否合适将直接决定机器的运行和输出功率。 - At the same time, the analytical expression for saturated signal output power is worked out as well.
同样也得出了饱和信号输出功率的表达式。 - Some realization ways of measurement are discussed, including the maximum output power, output amplitude and noise bandwidth.
讨论了低频噪声源的最大输出功率、噪声输出幅度以及噪声带宽测试的实现途径。 - Phase self-inductance, phase voltage, switching angles, DC bus voltage and shaft speed of the generator have been identified as design parameters and control variables affecting output power.
影响开关磁阻发电机（SRG）输出功率的参数和控制变量有相自感、相电压、开关角、直流侧电压和转速阐述了设计参数和控制变量对输出功率的影响。对SRG模型进行了仿真。 - The results show that the frequency and phase position of frequency converter output power are out of phase with that of supply power, which is the main reason leading to metering system breakdown.
分析结果认为：变频器输出电源的频率和相位与供电电源频率和相位不同步是造成计量系统产生故障的主要原因。 - The principle and conditions of optoelectronic feedback method, by which high stability output power could be realized, have been analyzed.
分析了用光电反馈方法实现高稳定激光功率输出的原理和条件。 - A blue dye laser with high output power in single mode is developed.
研制了一台蓝色高功率单模染料激光器。 - A backward-pumped large-mode-area ytterbium-doped double-cladding fiber amplifier with the highest output power of1.
报道了一种后向泵浦的大模面积掺镱双包层光纤放大器，输出功率为1。